Dupla CO2 Magnetventil Pro Mode D'emploi page 3

CO ² Solenoid Valve Pro
Thank you for choosing to purchase the Solenoid Valve Pro. With the CO ² Solenoid Valve Pro you have obtained a
product of the highest quality and reliability. These operating instructions are part of the product. They include important
information on commissioning and operation. Keep the operating instructions for future reference
Note: This solenoid valve must only be operated with low-pressure fittings that do not exceed an operating
pressure of 3.00 bar.
Connecting the CO ² Solenoid Valve Pro to CO ² Armatur Pro: For semi-automatic control by means of a timer
switch or fully automatic control by means of a pH value regulation, the CO ² Solenoid Valve Pro can be screwed
directly onto the CO ² Armatur Pro. Controlled via a timer switch, the CO ² Solenoid Valve Pro will interrupt the supply
of CO ² by closing when it is switched currentless and in this way can save up to 50 % of the CO ² consumption. Since
plants do not consume CO ² at night, the solenoid valve should here be synchronised with the light control for the
aquarium. Combined with a pH value regulation, the CO ² supply is optimised because only the exact amount consumed
is added to the aquarium. Thanks to its innovative electronic diode circuit, the CO ² Solenoid Valve Pro operates very
quietly, is energy-efficient and generates very little heat.
Assembly: The CO ² Solenoid Valve Pro is screwed between the fitting and the needle valve
needle valve to the connecting screw of the CO ² Solenoid Valve Pro
of the connections with 4 – 5 layers of Teflon tape
needle valve from the needle valve. Then screw the completely assembled CO ² Solenoid Valve Pro into the fitting
Align the CO ² Solenoid Valve Pro and check the threaded connections for tightness!
CO ² Solenoid Valve Pro technical data:
Voltage: 230 V
Max. Pressure: 0 – 3 bar
Power consumption: 2 W
(included in the delivery) to ensure 100 % tightness. Remove the
2
1
3
Hose union output: 4/6 mm CO ² hose
Thread: closed when currentless
. Then connect the
1
. It is essential that you wrap the outer thread
3
2
4
.
4
3