Loewe SL 150 Instructions De Montage page 23

3. Installing the Module (WLAN 70830 081)
Described as an example for the TV set Individual 32 Selection LED 200
The following description applies for the TV set: Individual 32 Selection Sound LED, ART 32 LED, Connect 32
LED.
MOS components
Avoid damage from electrostatic charging.
Observe the rules for handling MOS components.
Procedure
The following are required as a tool:
Screwdriver Torx T10, small fl at-nose pliers or tweezers
Preassembly of the WLAN antenna 3x MIMO (5)
Fasten the WLAN antenna 3x MIMO (5) on the antenna holder (6) with two screws M3 x 6 (7), as shown in Fig. 7 to 9, page
48. You need a Torx T10 screwdriver for this.
The catching pins of the antenna holder must enter the holes of the conductor board WLAN antenna 3 x MIMO (5).
Preassembly of the WLAN holder (11)
A contact foam must be bonded to the WLAN holder (11) as shown in Fig. 11 to 13, page 48.
This prevents potential interference.
Installation of the preassembled parts in the TV set
Fasten WLAN antenna with holder in the TV set.
Use 2 screws M3 x 6 (6) for this, follow Fig. 15 / 20, arrow, page 49.
Position the holder (11) in the TV set, as in Fig. 13, page 48.
Ensure that the latch noses latch into the support holes.
Holder fastened with the 2 screws M3 x 6 (6). You need a Torx T10 screwdriver for this.
Ensure that the contact foam (12) is present.
Fasten the WLAN module (3) on the holder already mounted with the 4 screws M3 x 6 (6).
Route the three antenna lines as shown in Fig. 20, page 49.
Route the antenna lines behind the other lines in the cable holders.
The two cable holders (9), Fig. 10 are not required for these TV sets.
Connect antenna lines coloured white to the top of the WLAN module (3).
Connect antenna lines coloured grey to the middle of the WLAN module (3).
Connect antenna lines coloured black to the bottom of the WLAN module (3).
Fix antenna lines with felt strip, if required.
Connect cable harness (5), as shown in Fig. 18/ 19/ 20, arrow, page 49.
Slide WLAN cover for protecting the WLAN module (3), Fig. 19, arrow.
The cable harness (4) is not required for this TV set.
Finally, carry out a function and safety check.
23