Bosch PRIO Lithium-Ion Notice Originale page 19

Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
06
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
23.06.2009
Assembly
Before any work on the machine (e. g. main-
tenance, changing the tool, etc.) as well as
during its transport and storage, lock the
On/Off switch in the off position. There is
danger of injury when the On/Off switch is
unintentionally actuated.
Battery Charging (see figure A)
Do not use other battery chargers. The sup-
plied battery charger is designed for the Lith-
ium-Ion battery in your machine.
Observe the mains voltage! The voltage of
the power supply must correspond with the
data given on the nameplate of the battery
charger. Battery chargers marked with 230 V
can also be operated with 220 V.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The Li-ion battery is protected against deep dis-
charging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
Bosch Power Tools
Dr. Eckerhard Strötgen
Head of Product
Certification
Do not continue to press the
WARNING
On/Off switch after the ma-
chine has been automatically switched off. The
battery can be damaged.
Insert the machine into the battery charger 5 as
shown in the figure. Pay attention that the
charge connector 6 engages in the correspond-
ing socket of the machine. The charging proce-
dure begins as soon as the mains plug of the
battery charger is plugged into a socket.
The charge-control indication 2 indicates the
charging progress. During the charging proce-
dure, the 3 LEDs light up one after the other and
briefly go out. When the 3 LEDs light up contin-
uously, the battery is fully charged.
During the charging procedure, the handle of
the machine warms up. This is normal.
Disconnect the battery charger from the mains
supply when not using it for longer periods.
Protect the battery charger against mois-
ture!
Observe the notes for disposal.
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
English | 19
1 609 929 S57 | (8.7.09)