General safety information
•
Explosive gases are produced during the charging process. It is important that all naked flames and sparks (including cigarettes)
are kept away from the charger.
•
This charger is designed for indoor use in well ventilated areas on a flat stable surface. Do not use outdoors or in damp
environment.
•
Disconnect the mains power supply before connecting or disconnecting the charging cables.
•
Connect the charger carefully. Make sure the red clamp is attached to the battery positive terminal and the black to the negative.
Do not reverse the clamps or allow them to touch each other.
•
Please read all the relevant safety instructions and guidelines for any vehicle or equipment connected to the battery charger to
ensure compatibility.
•
Do not cover the charger. Allow air to the charger as it will overheat. The charger is equipped with a time-lag fuse inside.
Overheating will trip the fuse to prevent damage and will not reset until sufficiently cooled.
•
Do not use the charger within the vehicle. Stand it on a level firm surface to prevent damage to the charger or vehicle.
•
Do not tamper with this product. Repairs and maintenance must be carried out by an authorized service agent. Only use original
spare parts. Do not modify this product in any way.
•
Wear approved safety goggles (not safety glasses) and latex/nitrile gloves. Before charging a maintenance type battery the
electrolyte (battery acid) must be filled to the maximum marked level. Never use tap water. Distilled water or electrolyte must be
used.
•
Never use this equipment to charge non-rechargeable batteries.
•
Never attempt to charge a frozen battery.
•
Never attempt to charge a damaged or distorted battery.
•
Keep out of reach of children.
•
The battery terminal not connected to the chassis has to be connected first. The other connection is to be made to the chassis,
remove from the battery and fuel line. The battery charger is then to be connected to the mains.
•
When working around batteries, remove metal jewellery and take care where any tools are placed, e.g. spanners. A short circuit
caused by bridging the live terminal and ground can result in severe burns.
•
If battery acid contacts the skin or eyes, flush immediately with clean water for 15 minutes and the seek medical attention.
Technical data
Voltage
Charging voltage
Starting capacity
Charging current
Reference capacity
Absorbed power
Dimensions
Weight
Description
(Fig. 1)
1
Carry strap
2
Ammeter
3
Power on/off switch
4
MIN/BOOST function switch
5
Charger/Starter function switch
6
®
NOVA 50S
V
230
V
12/24
Ah
20
A
40
Ah
40 - 700
kW
Charging 1.2 - Start 7
mm
325 x 310 x 215
kg
14.500
6
12/24V connections
7
Fuse
8
Front cable storage
9
Battery terminal clamps
10
Plug
NOVA 50S - NLFRENES - v1.0 - 20122013
EN