Kolcraft AQ600 Instructions De Montage page 2

End
This product works with multiple cribs- illustrations may vary from your model
Step 1:
A. Undo the six screws attaching the Side to the Ends and remove the side.
B. If it is not already, adjust the Mattress Support to its lowest position by loosening the
four screws on the support arms, moving them to the low position holes, and tightening all
four screws.
Undo 3 screws on
each side
Mattress Support
Should be set to lowest position
Side
High Position
Middle Position
Low Position
Thread and tighten
all four screws