Makita DCL180 Manuel D'instruction page 7

Put on filter until it is fully in position on the
cleaner unit.
NOTE:
Make sure filter is put on straight
•
without being peeled back. If filter is put
on incorrectly as shown in diagram,
dust will get into motor housing, and
cause motor failure.
1
010005
Connect prefilter. At this time, make sure to
twist prefilter so that securing lip is firmly
locked into cleaner unit.
1
009999
010000
Connect capsule. Align O symbol on
capsule with O symbol on handle and then
firmly twist capsule in direction of arrow until
it is secured.
1. Filter
1. Prefilter
7
1
010001
010002
NOTE:
Always remove dust ahead of time, as
•
suction power will be reduced if there is
too much dust in cleaner.
Always be sure to check that both filter
•
and prefilter are loaded correctly prior
to using cleaner. If they are not loaded
correctly, dust will get into the motor
housing, and cause motor failure.
If the following examples occur, filter
and prefilter are not loaded correctly.
Reload them
problem.
Problem Examples
Example 1: Only prefilter has been loaded
(no filter)
010003
1. Mark
1. Handle
1
2. Capsule
2
correctly to
1. Prefilter
1
rectify