Setting Up; Mains Connection - Medion MD 17024 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.1. Setting up

WARNING!
Risk of fire/short circuit
There is a risk of short circuit or fire if the appliance is
set up incorrectly.
 Place the appliance on a heat-resistant, sturdy, level surface.
 Avoid the use of extension cables in order to prevent tripping.
 Never place the appliance on the edge of a table – it could tip
over and fall.
 The casing becomes hot during use. Therefore, only touch the
appliance during operation using the buttons and handles
provided for this purpose.
 Do not position the appliance over a hotplate or other
heat-generating appliances (grill, deep fat fryer); this applies
even if an extraction fan is installed above it.
 Never set up the device near to a sink.
 Leave a little space between this appliance and other appli-
ances or the wall to allow the air to circulate freely. Do not
cover the appliance during operation.
 Do not use the appliance outdoors.

4.2. Mains connection

 Only connect the appliance to a properly installed 220–240
V ~, 50/60 Hz safety socket that is located close to the place
where you have set up the appliance. The socket must be
freely accessible so that you can unplug the appliance from
the mains quickly if necessary.
 Ensure that the mains cable has been completely unwound
during operation.
 Disconnect the appliance's plug from the socket after each
use, before each time you clean it, when the appliance is un-
supervised or if there is a fault.
 Always remove the mains cable from the socket by grasping
DE
FR
IT
EN
55 of 66

Publicité

Table des Matières
loading

Table des Matières