DEA SYSTEM Digipro Notice D'emploi Et Avertissements page 14

3.4 Adding user card and code (ZONE 1)
In setting mode:
Insert a 3-digit number (from 000 to 999) corresponding to the data storage box in which you
want to operate, the yellow led blinks:
a) If the red LED is lit, it indicates that in the chosen memory box data is already saved, press
the key twice to clear the memory;
b) If the green LED is on, it indicates that cards and passwords can be added in the chosen
memory box.
Steps to add cards and passwords:
• In setting mode, the yellow LED blinks.
• Insert the 3-digit number (from 000 to 999) in the data storage box in which you want to add
the user, the green LED lights up.
• Approach the card, the sound "BI" indicates that it was added. Then insert the desired pas-
sword (relative to the just added card). The password length must be the same of the admin
code. For example, if the admin code is 12 (2 is the length) you have to set a 2-digit password
(from 00 to 99). if the admin code is 123 (3 is the length) you have to set a 3-digit password
(from 000 to 999). The rest may be deduced by analogy and the maximum is 6 digits long...
The "BI" sound, indicates that the password was correctly set.
• Press to exit the setting mode.
3.5 Erasing user card and code (ZONE 1)
In setting mode:
Insert a 3-digit number (from 000 to 999) corresponding to the data storage box in which you
want to operate, if the red LED is on, it indicates that in the chosen memory box data is already
saved, press the
3.6 Adding user card or code (ZONE 2)
In setting mode:
• Press followed by
sponding to the data storage box in which you want to operate, the yellow LED blinks.
a) If the red LED is on, it means that inside the chosen memory box data is already saved,
press the key
b) If the green LED is on, it means that cards o passwords can be added in the chosen data
storage box.
• Approach the card, the sound "BI" indicates that you added it; OR insert the desired pas-
sword; the password length must be the same as the admin code. I.g., if the admin code is 12
(2 is the length) you must set a 2-digit password (from 00 to 99). If the admi code is 123 (3 is
the length), you must set a 3–digit password (from 000 to 999). The rest may be deduced by
analogy...The sound "BI" indicates that the password was correctly set.
• Press to exit the setting mode.
3.7 Erasing user card or code (ZONE 2)
In setting mode:
Press followed by
ding to the data storage box in which you want to operate, if the red LED is on it indicates that
in the chosen memory box data is already saved, press the
12
key twice to clear the memory.
, the yellow led blinks, insert a 2-digit number (from 00 to 09) corre-
twice to erase the memory.
, the yellow LED blinks, insert a 2-digit number (from 0 to 09) correspon-
key twice to erase the memory.