Hendi 222836 Mode D'emploi page 10

Troubleshooting
If the machine does not function properly, please check the below table for the solution. If you are still una-
ble to solve the problem, please contact the supplier/service provider. DO NOT repair yourself.
Problems
Machine do not start running
Machine stops during operation
Machine sound too noisy
EN
Attachments cannot
onto the planetary shaft easily
Bowl lift / lower handle (9) not
operation easily
Technical specification
Item no.
Operating voltage and frequency
Rated input power
Net weight (approx.)
Protection class
Waterproof protection class
Rotation speed (r.p.m.)
Maximum bowl capacity
Maximum amount flour mixing
Max noise level
Outer dimension
Remark: Technical specification is subjected to change without prior notification
10
Possible causes
Bowl guard (5) is not in properly closed position.
Bowl (2) is not raised to the proper location.
The power plug is not connected properly.
Internal overload activates to prevent overheat.
Damage or broken transmission belt
Machine is not placed on a horizontal surface.
Bowl (2) is not placed correctly.
Attachments not fitted properly.
Bowl is overloaded.
Damaged or worn transmission belt.
Planetary gear needs lack of lubricant.
install Lack of lubricant and / or cleaning of the plane-
tary shaft required.
Lack of lubricant on the bowl slides.
Dough hook
Flat beater
Whisk
Possible solution
Rotate the bowl guard (5) to the right until ful-
ly closed properly.
Raise the bowl (2) to the correct position by
using the level (9).
Check to make sure the power plug is con-
nected properly.
Press RED, "O" button (8), unplug the ma-
chine, leave for cook down completely, press
RESET button (10) at the back.
Check with the supplier
Adjust the surface or move to another hori-
zontal surface.
Make sure the bowl (2) is placed into the bowl
cradle (12) correctly with the guided pins (3).
Remove and install the attachments into po-
sition again.
Reduce ingredients capacity.
Check with the supplier.
Wipe planetary shaft with a clean damp cloth
and lubricate the shaft with mineral oil or
grease.
Lubricate bowl slides with mineral oil or
grease.
222836
220 – 240 V~ 50Hz
600W
53kg
Class I
IP23
148
244
480
10L
2,5 kg
< 70 dB (A)
470 x 380 x (H) 730mm
222843
1100W
78kg
197
317
462
20L
5,0 kg
540 x 470 x (H) 870mm