Radio Reception; Recall Radio Preset Memory; Store Into Memory - Seg CR 105K Instructions D'utilisation

•
To
corresponding
<POWER ON/OFF>,

3.13 Radio reception

•
Press <POWER> once, the station frequency or the station name
show on LCD.
•
If RDS information is transmitted by the station current set,
"
station name appears in place of the frequency.

3.14 Recall radio preset memory

•
There are 60 preset memory stations for the radio
•
When the radio is ON, press <A,0-9> once. 'MEM' goes solid; the
frequency of the memory-0 goes solid in the LCD. Press <A,0-9>
again and again to select the preset memory between 0~9.
•
Similar to <A,0-9>, press <B,0-9>, <C,0-9>, <D,0-9> , <E,0-9>or
<F,0-9> to select the desired preset memory station.
•
When new preset memory key is pressed, MUTE is active. When
keying the preset memory has been released for 1 second, the
selection of preset memory is considered as valid and the radio
will be tuned to that frequency immediately with MUTE idle.
•
At any time, press other key to start its corresponding function.

3.15 Store into memory

•
To store the tuning frequency of radio station being received
into any of the preset memory, press < MEMORY SETTING > once.
The 'MEM' goes flashing
•
Select the desired memory station by pressing the corresponding
key until its number goes solid above 'MEM'
_____________________________________________________________
terminate the
key
" appears in the display and after short time the
currently active
<ALARM1/VOL.+>
-19-
alarm, press
or <ALARM2/VOL.->,
●
the
GB
●