Melitta bar-cube mc MP Mode D'emploi page 22

8. Use
After the device has been properly set up and
connected according to these instructions, you can
now prepare it for operation:
❍
If cleaning is first required, refer to chapter 10
for details.
❍
If you have previously moved the device, let it
stand still for 2 hours to allow the oil filling to
distribute itself uniformly.
When the warming feature is switched on, the stainless
steel bottoms become unpleasantly hot. Do not touch
them there is danger of burning.
GB
a) Fitting warming plate
Attention: The surface of the heating plate may
become scratched. Therefore exercise care when
setting up and removing the cups and glasses.
➁
Always place the cups and glasses with the
opening down into the cup cabinet. This will
keep the heat in the vessels
b) Refilling the milk
Use pre-cooled milk - the cooling power is designed
to keep items cool but not to cool down warm milk.
➃
Open the device door and ...
➄
Pull out the milk container by approximately one
third.
➅
Push the cover back and fill the milk into the milk
container.
➆
When closing the cover, check to make sure that
the milk suction hose is immersed in the milk.
You may now push the container in the
refrigerator and close the door.
c) Switching ON / OFF
The two ON/OFF switches are located behind the
opened door of the device. Use the ...
➀
the left switch to turn on the refrigerator and
➂
right switch to turn on the warming plate.
The device should be switched on approximately one
hour before use to allow the refrigerator to cool
sufficiently and the warming plates to heat up to
operating temperature.
Caution Hot!
➀ ➁ ➂
➃ ➄ ➅
6
➆