Publicité
Les langues disponibles
Les langues disponibles
Arm rest adjustments
The arm rest is designed for the weight of your patients forearms. Do not allow your patients
to push against the arm rest to lift themselves out of the chair.
To change the arm rest position
1.
Pull the buckle tab to lengthen the strap. Release the
cam lock. Lift or lower arm rest until your patient's
forearms rest comfortably on the pad and his/her
shoulders are comfortably rounded.
2.
Lock cam lock and tighten strap by pulling on it.
Helping your patient onto the chair
I
Have your patient stand on the right side of the chair and grasp
the chair frame just above the chest pad for support.
I
Have the patient straddle the seat and place left knee on the left
knee pad (farthest away from their body).
I
Your patient can then gradually begin to sit down. Once seated,
the patient can put right knee on the right knee pad.
I
You can then make the proper adjustments to the face and arm
rests for proper patient comfort and positioning.
Face rest adjustments for optimal patient comfort
Oakworks QuickLock™ Face Rest has virtually unlimited positioning.
1.
Show your patient how to get on the chair.
2.
Release the cam locks and knobs on the face rest. (Fig. 1)
3.
Ask your patient to sit down and hold onto the face rest on the
hook and loop fastener on the sides of the "U" tube. (Fig. 2)
4.
Tell your patient to pull the face rest toward his/her forehead until it rests comfortably
on the pad.
5.
Have your patient lean forward, letting the chair support his/her weight until in a relaxed position.
6.
Lock the cam locks first and then tighten the knobs.
• Do not over tighten the knobs - too much force may cause stripping. (Fig. 3)
• The face rest can be moved up and down after loosening the knobs and angled after releasing the
cam locks.
• The face rest platform cam locks are reversible.
1
2
3
Publicité
