Nolan N104 Sécurité Et Instructions D'utilisation page 20

N104 0072_N104 0072 26/08/11 09.50 Pagina 20
LINER ASSEMBLY
2.1 Insert the liner correctly into the helmet and fit it well against the base.
2.2 Insert the left front flap into the seat on the support fixed to the polystyrene inner
shell and push it slightly downwards until it is completely locked (Fig. 14). Follow
the same steps for the right and central front flap.
2.3 Insert the rear flaps of the liner in their lower seats on the shell sealing edge as
shown in Fig. 13.
2.4 Carefully adjust the liner until it adheres well to the shell.
NOTE: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. If this is not the case, repeat the
steps 1.6 and 2.2.
ROLL NECK ASSEMBLY
1.4 Insert the rear flaps of the roll neck in their upper seats on the shell sealing edge
as shown in Fig. 12.
1.5 Fasten the side flaps (2 on the left and 2 on the right) as shown in figure 15.
1.6 Fasten the side eyelets of the roll neck before assembling the cheek pads as
shown in figure 11B.
1.7 Once the cheek pads are fastened (next paragraph), fasten the roll neck to the
cheek pads with the hook-and-loop strip (Fig. 11A).
CHEEK PAD ASSEMBLY
2.5 Insert the band and the left chin strap into the slot of the left cheek pad.
2.6 Place the left cheek pad against the polystyrene inner cheek pad as shown in
figure 16.
2.7 Push the padding of the cheek pad in line with the snap fasteners on its back in
order to fasten them to their seats (Fig. 11B).
2.8 Repeat these steps with the padding of the right cheek pad.
2.9 Fasten the roll neck to the cheek pads with the hook-and-loop strip (Fig. 11A).
WARNING!!!
- Remove the padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely restored.
- Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
- Rinse off with cold water and dry up at room temperature away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material, in fact it is apt to change
or get partially destroyed to help absorb shocks.
- Use a damp cloth to clean it and let it dry at room temperature away from direct
sunlight.
- Do not modify the helmet's internal polystyrene components in any way.
- Never use tools or equipment of any sort to carry out the steps described above.
20