Assembly - Southland SOWST4317 Mode D'emploi

Assembly

• Save all instructions
Parts Included With The Packaged Trimmer:
• Operator's Manual
• Upper and Middle Handles
• Trimmer Guard
• Spark Plug Wrench and 5mm hex wrench
• Replacement String
• 50:1 2-Cycle Engine Oil (2 .6 Fluid Ounces .)
• Front Tube with Trimmer Head
• (2) Wheel Assemblies
• (2) Wheel Hex bolts
• (4) Washers for Wheel Bolts
WARNING
Do not operate Trimmer if it is damaged or not securely and fully assembled .
Tools Needed For Assembly:
• 10 mm wrench or adjustable wrench
• 14 mm socket or open wrench
Unpacking:
1 . Remove components from carton .
2 . Remove foam and corrugated protection .
A
Handle Assembly:
1 . Install straight round middle handle to lower handle
and secure using two M6 x 35 hex bolts and locknuts .
(Fig . 1)
2 . Route throttle cable through legs of upper handle .
Install upper handle to middle handle and secure using
two saddle bolts and plastic knobs . Install saddle bolts
from opposing sides so plastic knobs will not interfere
with each other . Orient handle so the "V" shape is
upward . Tighten knobs securely . (Fig . 2)
3 . Secure throttle cable to the underside of the middle
handle using the two spring clamps which have been
installed at the factory . (Fig . 3) Inspect throttle cable to
assure generous loops . Do not kink cable .
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or find any parts missing,
CALL TOLL FREE: 1-800–737-2112
• (2) Plastic Wing Nuts (For Attaching Handles)
• (2) Saddle Bolts (For Attaching Handles)
• (2) Hex Flange Screws, M6 x 35 (For attaching Lower
Handle
• (2) Hex lock nuts, M6
• (1) Hex Head Cap Screw M6 x 16 (For Attaching
Trimmer Guard)
• (1) Socket Head Screw, M6 x 12 (For alignment of
trimmer head tube to housing)
MIDDLE
HANDLE
LOWER
HANDLE
SPRING
CLAMP
EN-6
Copyright © 2018 MAT Engine Technologies, LLC
UPPER
HANDLE
MIDDLE
HANDLE
Fig. 1 Fig. 2
THROTTLE
CABLE
Fig. 3