Safety Definitions
• Save all instructions
Safety Alert Symbols:
The information listed below should be read and understood by the operator . We utilize the symbols below to allow the
reader to recognize important information about their safety .
DANGER
WARNING
CAUTION
NOTICE
Safety Warning Symbols:
Look for this symbol to point out important safety precautions . It means: Attention! Become Alert!
Your Safety Is Involved.
Read, understand and follow operator's manual before operating this machine. Failure to follow
directions could result in serious injury .
Always wear eye protection that meets or exceeds the requirements of ANSI Z87 .1 .
Wear hearing protection .
Wear safety footwear .
Engine exhaust contains carbon monoxide, an odorless and deadly gas . NEVER run unit indoors
or in a poorly ventilated area .
Keep all by-standers at least 50 ft . (15 m) away . Stop machine if anyone enters the area .
This equipment can throw small objects at high speed causing personal injury . Inspect area
where used and remove all foreign objects .
Keep all parts of your body away from the rotating trimmer lines .
To reduce risk of fire, clean spilled gas and keep unit free from debris . Gasoline is extremely
flammable . Allow machine to cool before refueling .
Hot surface . Do not touch a hot muffler, gear box or cylinder, you may get burned . These parts get
extremely hot from operation and remain hot for a short time after the unit is turned off .
Control and Operating Symbols:
CHOKE/
COLD
Choke Control:
START
Cold Start
Run/Warm Start
RUN/
WARM
START
CHOKE/
COLD
START
Fuel Primer:
6x
Press 6 times
RUN/
WARM
START
Questions? Call Toll Free at 1-800-737-2112
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury .
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury .
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury .
Indicates a practice not related to personal injury which, if not avoided, may result in property damage .
Fuel Mixture
50:1
Unleaded Gas: 2 Cycle Oil
Caution: Do Not Use Gas
Mix with More Than 10%
Methanol or Ethanol
ON/
STOP
RUN
EN-2
Copyright © 2018 MAT Engine Technologies, LLC
Fuel Mixture:
50:1
(Unleaded Gas : 2 Cycle Oil)
Ignition Switch:
ON
OFF