PIZZA GROUP FLAME Notice D'utilisation page 29

 Fit a 10A at 2P+T plug to the end of the power supply cable;
 connect the plug to the electrical mains.
The electrical outlet must be easy to access, no moving should be
necessary.
!
The electrical connection must be easily accessible, also
following hood installation.
The distance between the hood and the socket must be adequate so that
the power supply cable is not strained. In addition, the cable must not be
located beneath the hood base.
!
If the power supply cable is damaged, it must be replaced by
the technical assistance service or by a qualified technician to
prevent any risks.
4.2.1.1 Earth connection
It is mandatory that the electrical system is equipped with an
earth connection.
In compliance with current regulations, the equipment must be
connected to an equipotential system whose efficiency must be correctly
assessed according to applicable standards . The connection is made on
a specific terminal located to the side of the black terminal block, with a
cable with a minimum section of 10mm
This terminal is marked with the following symbol:
2
.
- 30 -