Publicité
Les langues disponibles
Les langues disponibles
English
1.
To fix the tool holder to the machine,
introduce the shank and choose the
desired slop.
Then tighten the 3 screws of fixations.
(Important, watch that the screws have
the same strength of tightening).
2. Adjust the offsets of 2 positions.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSE-1207-3x
3. During the mounting or the dismounting of
your cutting tools, block the broach on
flats planned for that purpose, using an
adapted wrench.
4. The tool shank diameter should never
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
NOTE :
positions. Use the supplied protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation: 03.07.14
Never use the tool holder with empty
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document:
GSE-1207-3x Mode
d'emploi 1- .docx
Page: 2 de 4
Publicité
