Buffalo CD410 Mode D'emploi page 3

Telephone Helpline: 0845 146 2887
Operation
Place the plug in the electric socket to connect electricity.
Partly fill the Body with water, place the Liner inside the Body, then place the Top Ring over the lip of the
Liner to secure in place.
Pour the hot soup or food in to the Liner, then position the Lid on the Top Ring.
Switch on electricity at socket.
Start heating by rotating the control knob clockwise.
Cleaning, Care & Maintenance
Disconnect from electricity supply, allow to cool before emptying the water from the Body, always use
fresh water when the kettle is to be used.
Always wash the Kettle Liner, Top Ring and Lid after every use.
Wipe both exterior and interior of the Body to remove any food residues, do not immerse the Body in
water or clean with a pressure washer.
Trouble Shooting
Fault
Indicator Light does not
come on & Warmer does not
heat up
Indicator Light comes on but
Warmer does not heat up
Technical Specifications
Code Voltage
CD410 240V/50Hz
43744 - CD410 Soup Kettle.2.indd 3
Probable Cause
Power is not switched at socket
Plug fuse has failed
Power cable is damaged
Thermostat has failed
Heating element has failed
Thermostat has failed
Power Watts Current Amps
300 1.3
Action Required
Turn power on at socket
Change fuse
Call BUFFALO dealer for repair service
Call BUFFALO dealer for repair service
Call BUFFALO dealer for repair service
Call BUFFALO dealer for repair service
Dimensions mm Weight Kgs
348 x 270 x 234 2.94
UK
3
23/12/09 14:19:49