Buffalo CD410 Mode D'emploi page 2

UK
Safety Tips
• Position on a flat, stable surface
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove and components or service panels on this product
• Consult Local and National standards to comply with the following:
• Health and safety at work legislation
• BS EN Codes of practice
• Fire Precautions
• IEE wiring regulations
• Building regulations
• DO NOT use jet/pressure washers to clean the appliance
• DO NOT use the appliance outside
• DO NOT use the appliance to store medical supplies
• DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-cream makers etc)
• DO NOT allow oil or fat to come into contact with the plastic components. Clean immediately if contact
occurs
• DO NOT store products on top of the appliance
• Always carry, store and handle the appliance in a vertical position and move by holding the base of the
appliance
• Always switch off and disconnect the power supply to the unit before cleaning
• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of
local authorities
• If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified
technician in order to avoid a hazard
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety
• Children should be supervised to ensure that they do not play with the appliance
Product Description
CD410 Buffalo 5.7L Cylindrical Soup Kettle
Pack Contents
Body Assembly
Top Ring
Installation
Remove all packaging and dispose of safely.
Wash Liner, Top Ring and Lid in warm soapy water, rinse in clean water then dry thoroughly.
2
43744 - CD410 Soup Kettle.2.indd 2
Kettle Liner
Lid Assembly
23/12/09 14:19:49