Start-Up; Things Not To Do - Luxia OCEANO 35 Manuel D'utilisation

To start the dishwasher:
1) Open the loading water tap and activate the
switch at the mains.
2) Insert the overflow pipe (5) into the proper
hole, making sure that the rotor (in models
with a square basket) can rotate freely.
3) Close the door.
4) Press the starting switch (1) to load the water
into the tank and heat it up.
5) Pour in the appropriate amount of detergent
(non-foaming type) unless a detergent pump has
been installed; apply the dose recommended by
the detergent manufacturer.
5) Wait for the indicator lights (3) to go off.
7) Load the basket, put it in the machine in the
washing position and close the door.
8) Press the start cycle button (2).
9) Wait for the end of the washing and hot rinse
cycle, signalled by indicator (4) going off.
10) Open the door, wait a few seconds and take
out the basket with the clean dishes.
• Do not operate the machine when you are
barefoot.
• Do not pull the power supply cable to disconnect
the machine from the mains.
• Do not leave the machine exposed to the
weather (snow, rain, etc).
• Do not leave solid particles on the dishes to be
loaded into the machine.
• Do not put your hands into the tank when the
machine is on (you might touch the water
heating resistance!).
• Do not touch the door safety microswitch (a).
• Do not close the door if the basket is not correctly
positioned.
• Do not allow any use of the machine by children
or unexperienced people.
• Do not use the machine without the proper filter
(b) in the tank.
• Do not leave the machine main switch on when
you have finished using it.
• Do not oil in any way any part of the machine.
• Do not modify the temperature as set in the
factory; if necessary, call a specialized technician.
• Use only industrial detergents.
• Do not leave the machine in wash mode without
the overflow pipe.
pag. 38 di 116

20 - START-UP

21 - THINGS NOT TO DO

OCEANO 35/40/50/60
2
1
4
5
Operating and service manual
English
3
a
b