Grasslin talento taxxi plus Mode D'emploi page 18

Transferring switching programs to the time switch and vice versa
With the Prog� key, select the corresponding memory location P_1 ���� P_4
• Transfer the contents or
• With a memory location
1� Hold the handheld programming device directly on the two IR diodes (hold
the handheld programming device still during this operation)
2� Press the corresponding key twice, depending on the transfer direction –
in or out
3� Press the key once�
The transfer is prepared and the relevant program location and the
Z Z
assignment in or out flash alternately
4� Press the key again� The data is transferred�
An audible signal is output during the transfer�
Z Z
If the data has been correctly transferred, the number of the program location, e�g� P_ 1, can be
Z Z
seen in the display (of the handheld programming device)�
If the data has not been correctly transferred, there is a short, audible signal and the
Z Z
corresponding error message Er x appears in the display�
18