Metabo HPT UB 18DC Instructions De Sécurité Et Mode D'emploi page 15

4. Mounting on a wall for use
The work light can be used with its body
mounted on a wall using the hook-hole for wall
hanging. (Fig. 11)
Screw a wood screw, etc. into the wall with
the head of the screw protruding, then hang
the work light on it so that the screw passes
through the groove of the hook-hole for wall
hanging.
Hook-hole for
wall hanging
5. Securing to a tripod
The work light can be secured to a tripod using
the screw hole for tripod (5/8-UNC). (Fig. 12)
NOTE
When using a tripod, ensure that it is stable so
that it does not fall over.
Wood screw
Fig. 11
Tripod
Fig. 12
6. How to recharge USB device
WARNING
○ Prior to use, check the connecting USB
cable for any defect or damage.
Using a defective or damaged USB cable
can cause smoke emission or ignition.
○ When the product is not being used, cover
the USB port with the rubber cover.
Buildup of dust etc. in the USB port can
cause smoke emission or ignition.
Open the rubber cover of the USB port, and fi rmly
plug in a commercially available USB cable into the
USB port. (Fig. 13)
USB port
NOTE
○ If the remaining battery becomes low, USB
output is automatically stopped, and the work
light cannot charge USB devices.
○ The charging time diff ers depending on the
type of USB device being used.
○ Do not use for any purpose other than charging
a USB device.
○ It may not be possible to charge some types of
USB devices.
English
USB cable
Rubber cover
Fig. 13
15