Metabo HPT UB 18DC Instructions De Sécurité Et Mode D'emploi page 11

ASSEMBLY AND OPERATION
APPLICATIONS
Illumination of work site
REMOVAL AND INSTALLATION
METHOD OF BATTERY
○ How to install the battery.
Press the lock to release it, and open the
battery cover.
Always insert it all the way until it locks in place
with a little click. Then, close the battery cover,
and secure it with the lock. (Fig. 5).
○ How to remove the battery.
Open the battery cover, and while pressing the
2 latches (one on each side), slide it and pull it
out. Close the battery cover, and secure it with
the lock. (Fig. 6).
Press the lock
Open the
battery cover
Battery
Insert
Click
Fig. 5
Latches
(Both sides)
Press
NOTE
Ensure that the battery cover is securely
closed unless you are removing or installing
the battery.
If any water or dust enters the body of the tool
or the terminals of the battery, a failure may
occur.
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure
the following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn
out.
1. Connect the charger's power cord to a
receptacle. When the power cord is connected,
the charge indicator lamp will blink in red. (At
1-second intervals)
English
Pull out
Battery
Fig. 6
11