Switching On And Off; Cleaning/Maintenance/Storage; General Cleaning Instructions; Emptying The Pump - Grizzly GP 2832 K Traduction De La Notice D'utilisation Originale

GB
never come in contact with the
mains connection.
There is a risk of electrocution.
• Check the suction line.
The suction of the suction line
must be located in the water.
• Check the pressure line. The
end of the pressure line should
already be located at the water-
ing position.

Switching ON and OFF

Switching on:
On/off switch (
After a suction period the pump begins the
supply water.
Switching off:
On/off switch (
Avoid the dry running of the pump.
During the entire operation, monitor
the device and the water supply. If
there is not enough water available,
switch the pump off immediately.
The device is equipped with a ther-
mal overloading protection which
switches off if the engine if the
device overheats. To restart, allow
the equipment to cool then switch it
back on.
Cleaning/Maintenance/

Storage

Clean and maintain your equipment regu-
larly. This will guarantee its performance
and long durability.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts.
18
7) in "I" position.
7) in "0" position.
This will prevent damage to the
equipment and any resulting per-
sonal injury.
Pull out the power plug before eve-
ry maintenance operation. There
is a risk of electrocution or of injury
from moving parts.

General cleaning instructions

Do not jet water onto the appliance
and do not clean it under flowing
water. This would result in the dan-
ger of an electric shock and the ap-
pliance could be damaged.
• Clean the device with a damp cloth.
• Should blockages occur, remove the
suction pipe and pressure pipe. Rinse
out the foreign matter with water and
clean the suction filter.
• All other measures, particularly open-
ing the pump must be carried out by a
qualified electrician. Use our service
centre in the case of repairs.

Emptying the pump

If there is a danger of frost or longer peri-
ods of non-use (e.g. winter) the pump must
be completely emptied.
1. Open the drain screw (10) and
empty the water from the pump.
2. Rinse the pump with clear water.
Storage
• Keep the equipment clean, dry and out
of the reach of children.
• For storage, empty the pump (see
"Emptying the pump").