Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
tection measures are in place.
•
Do not carry or fix the equipment by
the cable or pressure line.
•
Protect the equipment from frost and
from running dry.
•
Use only original accessories and do
not carry out conversion work on the
equipment.
•
Please read the notes in the operating
instructions on the topic of "mainte-
nance and cleaning". Any measures
above and beyond these, particularly
opening the equipment, are to be car-
ried out by an electrician. In the case
of repairs, always contact our service
centre.
Electrical safety:
Caution: to avoid accidents and in-
juries from electric shocks:
•
After erection, the mains plug must be
freely accessible when the equipment
is in operation.
•
Before operating your new pump, have
a specialist check:
- The earthing, the protective multiple
earthing; the residual current circuit
breaking must be compliant with the
safety regulations of the energy sup-
ply company and function without
fault,
- The protection of the electrical plug
connections from the wet.
- If there is a risk of flooding, fix the
plug connections in an area that is
safe from flooding.
•
Ensure that the mains voltage matches
the specifications on the rating plate.
•
The electrical installation shall be ac-
cording to national wiring rules.
•
Connect the equipment only to a sock-
et with a residual current protection
device (residual current circuit breaker)
16
with a rated current of not more than 30
mA; minimum fuse 10 amperes.
•
Before each use, check the equipment,
cable and plug for damage. Defective
cables are not to be repaired, but rather
replaced by new ones. Have any dam-
age to your equipment repaired by a
specialist.
•
If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
•
Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
•
Do not carry or fix the equipment by the
cable.
•
Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the cable
for damage.
•
Before any work on the equipment, dur-
ing work breaks and in the case of non-
use, remove the plug from the socket.
•
Mains connection cables must not have
a cross-section that is smaller than
those of rubber hoses with the designa-
tion H07RN-F.
Initial Operation
Setting up
•
Place the device on a solid, horizontal
base which is also safe from flooding.
The horizontal alignment can be ad-
justed with the help of the jack screw
(
9).
•
If you would like to install the device,
screw it together with the base. A screw
connection with a fastening plate also
prevents the device from slipping.
By doing so, ensure a free access to
Publicité
Chapitres
Table des Matières
