Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1
1. Inspect roller cover for lint. For
best results, rinse roller cover
with water and let dry before
using.
WARNING–DO NOT REMOVE
INNER OR OUTER END CAPS
WITH A SCREWDRIVER!
DAMAGE TO END CAPS CAN
OCCUR.
4-5
4. Assemble roller assembly onto
Pro Electric Paint Roller handle
assembly and tighten nut.
• NOTE: When inserting frame,
crimped end, into handle the
washer on the frame will not be
flush to the handle.
5. Attach roller frame to handle.
CAUTION: Be sure to read and understand the assembly instructions before proceeding to the
painting instructions. Prior to use, the paint should be thoroughly mixed and free of debris.
C820429A_MAN_Pro Electric.indd 5

Assembly

2
2. Ensure the outer end cap is in the open position by depressing PUSH
TO REMOVE side of the tab. Assemble the roller cover to the roller
frame by inserting the frame inside the inner end cap.
Push roller cover onto the roller frame until the roller cover stops.
NOTE
• NOTE: If the 16-inch extension
handle is to be used, attach
the roller frame to the 16-inch
extension handle and then attach
the extension to the handle.
PRO ELECTRIC PAINT ROLLER (C800804)
6
6. If using spatter shield, attach
spatter shield by sliding over
outer end cap and clipping
forked end onto roller frame.
Adjust to any position.
• NOTE: Before turning the unit
on, make sure the Rapid Clean™
Plug is tightly screwed into the
Adapter or material will leak
from the Rapid Clean opening.
5
3
3. Lock end cap onto the roller
frame by depressing the locking
tab.
• NOTE: Pull gently on the roller
cover to ensure that the roller
cover is secured to the roller
frame.
ENGLISH
5/12/10 1:37 PM

Publicité

Table des Matières
loading

Table des Matières