SDMO AT206 Manuel D'utilisation page 57

6.4 – PROCEDURE FOR MODIFYING THE ADVANCED PARAMETERS
Modification of the parameters
Press the TEST button to access the parameter value.
Example:
1. The screen displays "P3.01"
2. Press the TEST button
3. The value of the parameter appears on the screen "3"
4. Press the START button
5. The parameter value increases
6. The screen displays "4"
7. Press the STOP button
8. The parameter value decreases
9. The screen displays "3"
10. Press the STOP button again
11. The screen displays "2", etc.
12. Exit without confirming → Press AUT
13. Exit by confirming the modification → Press RESET.
14. To exit the parameter setting menu → Press AUT then RESET.
23 / 32