Cleaning And Storage; Automatic Shutoff Feature - Unold Safety Lift 75014 Notice D'utilisation

cleaning anD Storage

1. allow the appliance to cool off before cleaning
it or store it.
2. Before cleaning and storing, always turn the
appliance off and unplug it from the wall
socket.
3. When disconnecting the plug from the wall
socket, do not touch the appliance as in this
case the Safety-Lift mode is not activated.
4. The iron should always be stored with the
Safety-Lift device extended in order to
avoid the generation of water drops on the
soleplate.
5. Discharge the water from the water tank. To
do so, just open the feed opening and tilt
the iron over a washbasin or sink until the
water runs out.
6. The soleplate should be cleaned regularly,
but in any case when it shows residues.
Let the appliance cool off and clean the
soleplate with a damp cloth. Do not use any
scrubbing sponges, abrasive agents, steel
wool, metal objects, disinfectants or hot
cleaning agents, since they can damage the
appliance.
7. In order to guarantee an optimum steam
generation, also the steam valve has to
be regularly cleaned from accumulations/
deposits. To do so, adjust the steam control

automatic Shutoff feature

If you do not use the iron for a prolonged time and the plug is still connected to the wall socket,
the indicator light starts blinking in red and indicates that the appliance has been switched off
automatically. To switch it on again, just touch the handle shortly.
The following table shows the different shut-off times:
Safety-Lift mode activated
Safety-Lift mode deactivated
attention: the Safety-Lift feature is an additional feature that facilitates ironing. Nevertheless, this is no
release from handling the appliance with the corresponding care.
8. The steam openings on the soleplate may
Ironing position
Horizontal, lifted
Vertical
Tilted
Horizontal, lowered: for safety
reasons, the appliance is
lifted by means of the Safety-
Lift device
from the „AUS/OFF" position to the highest
adjustment and back various times.
accumulate scale. In order to remove these
accumulations, fill the water tank with
water to the MAX mark. Heat the appliance
up, adjusting it to „Leinen" (Linen). When
the appliance has reached the indicated
temperature and the indicator light turns
green, adjust the material selector of the
appliance to „AUS/OFF" and hold it over a
washbasin or sink. Press the steam button
various times until the water leaks from the
soleplate. Please remember that the released
steam is very hot. Danger of burns!
Shut-off after
75014
8 min
8 min
30 sec
1 min
75025
8 min
8 min
30 sec
1 min
19