CDVI KCPROXWLC Mode D'emploi page 4

INSTALLATION MANUAL
KCPROXWLC
Dual Technology Digicode /Proximity reader
®
8] PROGRAMMING CHART
For the programming
connect the purple cable
with the black cable.
Switch the power supply
off then switch it on.
2 beeps are emitted
Red
LED ON
Programming Programming
illumination the output
keypad format
A0 A1
1 beep 1 beep
Green LED ON Green LED ON
Enter:
Enter the illumination - 1 = Wiegand format
time in seconds or - 2 = Standard format
"00" for a permanent - 3 = ISO Track 2
format
illumination.
1 beep = OK 1 beep = OK
Green LED ON Green LED ON
4 beeps = Error
4 beeps = Error
cdvi.com
6
cdvigroup.com
EN
Programming Programming the
the code lenght Bit format
A2 A3
1 beep 1 beep
Green LED ON Green LED ON
Enter: Enter: 26, 30 or 44
to define the Bit number of
4, 5 or 6 to specify the
number of digits. the Wiegand format
1 beep = OK 1 beep = OK
Green LED ON Green LED ON
4 beeps = Error 4 beeps = Error
INSTALLATION MANUAL
KCPROXWLC
Dual Technology Digicode /Proximity reader
®
Programming
Centaur or
Standard format
A4
1 beep
Green LED ON Green LED ON
Enter:
Enter : - 0 = Decimal mode
- 0 = Centaur mode - 1 = Hexadecimal mode
- 1 = Standard format - 2 = ARK mode
1 beep = OK 1 beep = OK
Green LED ON Green LED ON
4 beeps = Error 4 beeps = Error
For the programming connect
the purple cable with the black
cable. Switch the power supply
Kaypad Programming
programming the audible signal
A5 A6
1 beep 1 beep
Green LED ON
Enter:
- 0 = disable the
keypad beeps
- 1 = Enable the
keypad beeps
1 beep = OK
Green LED ON
4 beeps = Error
off then switch it on.
2 beeps are emitted
cdvi.com
cdvigroup.com
EN
7