DURAVIT C14290 010U Notice De Montage Et D'utilisation page 4

These instructions are part of the Duravit
product and must be read carefully and kept
available at all times.
Target readership and qualifications
The product may only be installed by a qualified
plumber.
Explanation of the key words
Addresses practices not
NOTICE
related to physical injury.
Technical data
Operating pressure
Recommended
Max. burst pressure
1 MPa = 10 bar = 145 PSI
Hot water temperature
This unit meets or exceeds the
following:
• ASME A112.18.1
• CSA B125.1
• ADA Compliant
4
MAL_57167/20.10.4
Safety instructions
Cut and crush injuries
> Wear gloves when installing the product.
Product and/or property damage
> Observe the local installation regulations and
> Equalise pressure differences between cold
> Observe the manufacturer's instructions for
> Flush the pipes according to the applicable
max. 125 PSI
50 PSI
500 PSI
max. 140 °F
any country-specific standards at all times.
and hot water connections.
installation with continuous flow heaters.
Malfunction due to dirty
NOTICE
pipes
standards before mounting the pressure
balance trim.