Buffalo CN295 Mode D'emploi page 5

Cleaning, Care & Maintenance
Always turn off and disconnect the appliance from the power supply before
cleaning.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
De-scaling
In hard water areas lime scale can build up within the appliance after prolonged use. For best taste and
extended appliance life, de-scale it regularly. Installation of a water filtration system is also recommended.
To de-scale the appliance:
1. Pour a solution of de-scaler and water into the appliance.
2. Brush the interior gently with a soft bristled brush.
3. Discard the solution collected in the jug.
4. Fill the appliance with clean water and turn back On to flush out the system. Flush out the system
thoroughly to remove any de-scaler residue.
5. The appliance is now ready for use.
Note: Use a suitable de-scaler and always follow the instructions on the
container.
Buffalo recommend that this appliance is de-scaled every 3 months or more
frequently in hard water areas.
IMPORTANT: Failure to de-scale or maintain will invalidate your guarantee.
Troubleshooting
If your Buffalo appliance develops a fault, please check the following table before making a call to the
Helpline or your Buffalo dealer.
Fault
The appliance is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Thermal cut-out switch has activated Reset Thermal cut-out switch
The appliance turns Lime scale build up in Percolator tube De-scale appliance
on but does not
make coffee
The tap is leaking The tap has become loose
CN295_ML_A5_v3_20201228.indb 5 CN295_ML_A5_v3_20201228.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Call Buffalo agent or qualified Technician
Replace the plug fuse
Check power supply
Call Buffalo agent or qualified technician
Tighten the tap handle
UK
5
2020/12/28 15:55 2020/12/28 15:55