Buffalo CN295 Mode D'emploi page 4

UK
3. Slot the Filter basket over the Percolator tube. Fill the Filter basket with the desired amount of ground
coffee.
4. Place the lid on the Coffee Percolator. Twist to lock.
5. Connect to the power supply. Set the ON/OFF switch to I (ON position) to begin brewing the coffee.
The 'BOIL' light illuminates.
WARNING: The lid of the appliance becomes very hot during use. DO NOT
TOUCH!
6. The 'READY' light is illuminated when the coffee has been brewed. The coffee is kept at serving
temperature by the percolator.
7. Turn the ON/OFF switch to O (OFF position) when the level indicator is almost empty, or the
equivalent of 3 cups of coffee is left in the urn, to prevent any damage to the heating element.
Note: DO NOT allow the appliance to boil dry. This invalidates the warranty.
Serving
• Place a suitable vessel beneath the tap.
• Pull the tap towards you to begin dispensing the coffee.
• Raise the tap handle to close the tap.
Emptying the Appliance
Drain the appliance by using the tap to empty the urn.
Thermal Cut-Out Reset
This appliance is fitted with a Thermal Cut-Out safety feature. Should the temperature exceed safe levels,
the appliance will automatically cut power.
The Safety Cut-out switch is located on the underside of the appliance. To reset the appliance:
1. Empty the appliance and allow to cool.
2. Press the reset button until it clicks.
WARNING: Ensure the appliance has cooled down and is empty before resetting
the switch, as it may need to be tipped slightly to gain access to the switch.
3. The appliance is now reset and can be used as normal.
4
CN295_ML_A5_v3_20201228.indb 4 CN295_ML_A5_v3_20201228.indb 4 2020/12/28 15:55 2020/12/28 15:55