Transfer Of Data To A Pc; Deleting Data; Communication; Ir/Rs232-Protocol - HUBER INSTRUMENTE HM35 Mode D'emploi

Notes
1) „Over" (data type DISCRETE) for invalid pressure value
2) For the Data Type key, refer to the table on Page 52.
3) User-interval period will, for example, be displayed as follows, "user 01:15:00"
3.6.2

Transfer of data to a PC

(with HM35 Communication Software)
Install the IR (IrDA) -adapter according the instructions of the manufacturer.
1.
Install the HM35 Communication Software.
2.
Start the HM35 Communication Software.
3.
Place the instrument max. 20 cm from the IR (IrDA)-Adapter and switch it on.
4.
Ensure a line-of sight connection between instrument and IR-adapter!
If there is no communication with the instrument for more than 2 minutes, the IR
interface of the instrument turns off automatically! By restarting the instrument the
IR interface is reactivated.
3.6.3

Deleting data

In the Menu, select the Data Logging → Clear Memory function.
1.
Press the Clear key.
2.
3.7

Communication

3.7.1

IR/RS232-Protocol

COM-Port Settings
Baudrate 9600
Data bits 8
Parity no
Protocol no
Stop bit 1
Communication Protocol
Coding
The characters are transfered as ASCII-Code.
44