Tabuchi Electric EHW-S55P3B-PNUS Manuel D'installation page 25

3
Start up the inverter.
① Set the DC Switch-Disconnector to the ON position.
② Confirm that the Hybrid Solar Inverter LCD panel looks similar to the screen shown below.
＊ The Remote Controller should read "VERIFY STAND-ALONE OPERATION AND COMMUNICATION WITH THE STORAGE BATTERY
UNIT." Values are approximated.
Bus Voltage: Approx. 420V
Operating Mode
(Default setting: BACmod)
4
Remote Controller initial settings
When the inverter is switched on initially, "TIME & DATE SETUP" will appear.
① Set date and time and press enter by setting cursor position on "DETERMINE DATE & TIME" .
② "SETTING VALUE" will appear after "DETERMINE DATE & TIME" .
Press "ENTER" . "SERVICE MODE 1/2" will appear.
③ Press "BACK" and back to home screen.
Storage battery charge (%)
Not for customer use
25