Beyerdynamic Opus 300 Notice D'utilisation page 36

1. Mount the ZAS 800 antenna splitter and the NE 300 receivers into a 19" rack by using
the mounting brackets.
2. Connect the supplied antennae to the antenna sockets A/B
remote antennae. For mounting the antennae on the front use the optional FB-30
mounting bracket.
3. Connect the NE 300 receivers to the ZAS 800 antenna splitter with the supplied cables.
4. Connect the power supply unit to the DC-connection
Make sure that the indicated voltage corresponds to the local voltage.)
5. Switch on the ZAS 800 antenna splitter
1.11.3 General Information
1. The antenna sockets
must not touch the rack housing.
2. For the connection of remote antennae use usual 50Ω coaxial cables. The longer the
cable, the higher the RF signal loss. Therefore, the cable length should not exceed 6 m.
The larger the diameter of cable, the lower the signal loss. If you need cables longer
than 6 m you should therefore use cables with a larger diameter to reduce the loss of
signal.
3. Use 50Ω coaxial cables to connect the NE 300 receivers to the ZAS 800 antenna splitter.
The distance between these devices should be as short as possible. We recommend you
to use the supplied cables.
4. Supplied Accessories:
8 x RG 58 AU cables, 40 cm (TNC)
1 pair FB 30 rack mount brackets (incl. front mounting option)
1 x 12 V / 500 mA power supply unit
.
1
4 have a voltage of 8 V DC. To avoid a short circuit the sockets
. You can also use optional
4
and to AC power. (Attention:
3
37