Hkoenig STM45 Manuel D'utilisation page 11

PARAMETERS
PRODUCT OPERATIONS
Ironing:
1. Stand the machine assembled on flat and stable floor. Adjust the height and
spread range of the hanger as required and hang the clothes on it. Ensure
there is enough water in the water tank and the tank is located properly. Plug
the plug into the power socket, select the appropriate gear. Let the machine
preheat for about 40s, waiting for steam of ironing brush.
When the ironing brush shake or move from side to side, water bead may be appeared on
the handle of ironing brush ( Danger of scalding ).
2. Iron from the main part of clothes, hold the lower hem by hand gently to make the wrinkled part flat and
iron the rippled fibers out by the hot steam (as shown in Picture 2).
3. Press gently the metal panel of ironing brush on the clothes, move the brush up and down at such a
speed that the steam penetrates into the fibers appropriately for hot forming.
4. After ironing the main part, ironing the specific parts from up to down. When ironing the collar, you may
fold the whole collar back, hold one end of the collar by hand, move the ironing brush horizontally and,
during when, be careful of the hot steam (as shown in Picture 3).
5. When ironing the sleeves, pull the sleeves to
straight and move the ironing brush along the
sleeves.
Rated power: 2000W
Voltage: 220V-240V~50Hz
Steam pressure: 1.5bar
Steam flow: 45g/min (max)
Tank capacity: 1600ml