Important; Appliance Dimensions; Electrical Connection - Aqualytic TC Série Mode D'emploi

Setting up
• Do not place the appliance in direct sunlight or near
cookers, radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal
and level. Compensate for uneven floors with the
adjustable feet.
• Do not cover ventilation openings or grille.
• Always install the appliance directly against
the wall.
• Standard EN 378 specifies that the room in
which you install your appliance must have a
volume of 1 m per 8 g of R 600a refrigerant
3
used in the appliance, so as to avoid the
formation of inflammable gas/air mixtures in
the room where the appliance is located in the
event of a leak in the refrigerant circuit.
The quantity of refrigerant used in your appliance is
indicated on the type plate on the inside of the appliance.

Important

When unpacking and setting up use protective gloves.

Appliance dimensions

A B
TC 140 G 850 mm 600 mm
TC 256 G 1640 mm 600 mm
Installing beneath a worktop TC 140 G
For continuous worktops the refrigerator's tabletop can be detached.
The refrigerator can then be pushed under the existing worktop.
• To take off tabletop remove screws ➊.
• A cross-section of min. 200 cm
top for ventilation of the rear of the appliance.
TC 140 G / TC 256 G_3 05/2019
C D E
600 mm 648 mm 1153 mm
610 mm 650 mm 1180 mm
is re quired in the work-
2

Electrical connection

Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type plate.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion of
direct current to alternating current/three-phase
current) or energy-saving plugs. Risk of damage
to the electronic control system!
Safety lock TC 140 G
The lock in the appliance door is equipped with a safety mechanism.
Locking the appliance
• Insert the key as
shown by arrow 1.
• Turn the key 90°.
To unlock the appliance, the same
procedure must be repeated in the
same order.
Safety lock TC 256 G
The lock in the appliance door is equipped with a safety mechanism.
Locking the appliance
• Insert the key as
shown by arrow 1.
• Turn the key 90°.
To unlock the appliance, the same
procedure must be repeated in the
same order.
Important
TC 140 G, TC 256 G
The maximum load per grid shelf is 45 kg.
GB
11