Operation - General; Before First Use - Bestron AST2200 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
user's instructions
operAtIon
- General
The appliance is intended only for domestic use,
not for professional use.
1. Ceramic soleplate
2. Water reservoir
3. Spray nozzle
4. Water filling funnel
5. Steam-control dial
6. Selection button steam/spray
7. Handle
8. Power cord and plug
9. Temperature indication light
10. Temperature-control dial
11. Filling cup

before fIrst use

Before using the iron for the first time begin by ironing a piece of old fabric to verify that the soleplate and
water reservoir are clean. Repeat this when the iron has not been used for a period of time. The appliance
may emit a little smoke and a characteristic smell when you switch it on for the first time. This is normal,
and will soon stop. Make sure the appliance has sufficient ventilation.
use -
fillig the water reservoir
1. Remove the plug from the wall socket.
2. Turn the steam-control dial to the
3. Fill the water reservoir with clean tap water.
Use the filling cup to fill the water reservoir.
Note Do not fill the water reservoir above the
'max' (200ml) level. Verify by this by standing
the iron upright. Excess water in the reservoir
could overflow during use and cause a short circuit.
4. Dry the exterior of the iron with a dry cloth (see Figure 2).
use -
Dry ironing
1. Put the plug into the wall socket.
2. Turn the steam-control dial to the
3. Turn the temperature-control dial to the required position (see 'Ironing instructions'). The
temperature-indication light will illuminate.
4. Stand the iron upright and wait until the temperature-indication light extinguishes.
5. Iron the fabric by sliding the iron over the fabric.While you are ironing the heating element will
automatically switch on and off to maintain the soleplate at the set temperature. Consequently the
temperature-indication light will also automatically illuminate and extinguish.
6. When you have finished ironing turn the temperature-control dial to the MIN position, remove the plug
from the wall socket, and stand the iron upright to allow it to cool.
10
6
5
4
3
1
2
position.
position.
19
9
7
11
8
Figure 1
Figure 2

Publicité

Table des Matières
loading

Table des Matières