Makita DFN350 Manuel D'instruction page 9

OPERATION
Testing the safety system
WARNING:
Make sure all safety systems are
in working order before operation. Failure to do
so may cause personal injuries.
1
2
3
► 1. Trigger-lock button 2. Switch trigger 3. Contact
element 4. Magazine
Test safety systems for possible fault before operation
as follows.
1. Unload nails from the tool and keep the magazine
opened.
2. Install the battery cartridge and release the trigger
lock.
3.
Only pull the switch trigger without touching the
contact element against the material.
4. Only touch the contact element against the mate-
rial without pulling the switch trigger.
If the tool operates in the case of 3 and 4 above, the
safety systems are faulty. Stop using the tool immedi-
ately and ask your local service center.
Driving nails
WARNING:
Continue to place the contact
element firmly on the material until the nail is
driven completely. Unintentional firing may cause
personal injuries.
1.
Release the trigger lock.
2.
Place flat the contact element on the material.
3. Pull the switch trigger fully to drive a nail.
4. To drive the next nail, release your finger from the
switch trigger once, and then repeat the step 2 and 3
above.
► 1. Switch trigger 2. Contact element
You can also drive the nails when dragging the tool to
the next area with the contact element pressed against
the material and pulling the switch trigger.
4
If the head of the nail remains above the workpiece sur-
face, drive the nail while holding the nailer head firmly
against the workpiece.
NOTE: If the head of the nail still remains above the
workpiece even you hold the nail head, the material
may not be suitable for the nailer. Continuing to use
the nailer on such material may result in a damage to
the driver of the nailer and/or nailer jamming.
9 ENGLISH
1
2