Makita DFN350 Manuel D'instruction page 8

2. Set a nail strip so that the nail tips touch the bot-
tom of the magazine and slide the nail strip toward the
firing opening.
3
► 1. Nails 2. Slide door 3. Driver guide
3.
Return the slide door to the original position until
the lock lever locks it.
To remove the nails, press the lock lever and slide the
slide door. Take out nails from the magazine.
Nose adapter
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
When firing nails on the material with easily-marred
surfaces, use the nose adapter. To attach the nose
adapter, put it onto the driver guide cover to the end.
You can store the nose adapter on the holder on the
back end of the magazine to keep it from being lost.
2
1
► 1. Nose adapter 2. Holder
2
1
8 ENGLISH
Hook
CAUTION:
Do not hang the hook from the
waist belt. Dropping the nailer, which is caused by
the hook accidentally coming out of place, may cause
unintentional firing and result in personal injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1
2
3
► 1. Groove 2. Hook 3. Screw
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► 1. Hex wrench
1