Braun Wet & Dry 7 Série Mode D'emploi page 13

Cleaning
Regular cleaning ensures better shaving
performance. Rinsing the shaving head under
running water after each shave is an easy and
fast way to keep it clean:
• Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
You may use liquid soap without abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, press the release
button to remove the Foil & Cutter cassette
2
and let it dry.
1
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil on top of the Foil & Cutter
cassette.
Alternatively, you may clean the shaver with a
brush:
• Switch off the shaver. Remove the Foil & Cutter
cassette and tap it out on a fl at surface.
1
Using a brush, clean the inner area of the
pivoting head. However, do not clean the foil
and cutter cassette with the brush as this may
damage it.
Keeping your shaver in top shape
Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance,
replace the Foil & Cutter cassette
replacement symbol lights up on the shaver
display (after about 18 months) or when
9
cassette is worn.
The replacement symbol will remind you during
the next 7 shaves to replace the Foil & Cutter
cassette. Then the shaver will automatically reset
the display.
After you have replaced the Foil & Cutter
cassette, use a ball-pen to push the reset button
for at least 3 seconds to reset the counter.
8
While doing so, the replacement light blinks and
goes off when the reset is complete. The manual
reset can be done at any time.
, when the
1
Series
Ser ies
r e l e as e
Series 7
r e l e as e
click!
Series 7
r e l e as e
Series 7
r e l e as e
Series 7
r e l e as e
r e l e as e
70S/70B
Series 7
r e l e as e
13