Safety Instructions - Velleman CAMCOLBUL11 Notice D'emploi

CAMCOLBUL11 – 1/3" IR COLOUR CCD CAMERA
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer. Contents: 1 x IR camera, 1 x video/power
cable, 1 x sun shield, 1 x bracket, 1 x screw and wall plug set and this manual.
This camera features an IR shifter, Smart Light Control and a large aperture lens providing sharp and clear images.
IR shifter: true colour images at daytime and automatic IR night vision with low visibility
Smart Light Control: dynamic adjustment for clear and accurate image
Large aperture lens: clear images at low power consumption

2. Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• Keep this device away from rain and moisture.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. Installation
You may need following tools: 1 x power drill and 1 x Phillips-headed screwdriver
• STEP 1
Choose a suitable mounting location and position the bracket onto the wall.
Mark the holes with a pencil, drill the holes and insert a plug into each of the
holes. Also drill a hole for the video/power cable.
• STEP 2
Remove the lock from the bracket using the wrench. Fix the lock onto
the camera. Choose the hole which best suits the installation location.
Push the sun shield a little forward to facilitate the installation.
CAMCOLBUL11
- 3 - VELLEMAN