Initial Operation; Starting The Egg Boiler - GUTFELS EK 8001 swi Notice D'utilisation

EN
• If necessary, place a non-slip
pad under the egg boiler.

11 Initial operation

Checking the egg boiler and the
scope of delivery
1
Check whether the scope of
delivery is complete.
2
Take the egg boiler out of the
packaging and check to see
whether it or the individual
parts are showing signs of
damage. If this is the case do
not use the egg boiler.
Contact the manager by
means of the service address
specified on the warranty
card.
Thorough cleaning
•
Remove the packaging
material and all protective
plastic films.
•
Clean all of the parts of the
egg boiler as described in the
chapter on Cleaning before
using it for the first time.
Set up
•
Fully unwind the mains cable.
• Guide the cable through the
cable notch on the side of the
egg boiler.
• Place the egg boiler on an
even, stable surface. This
surface should be easy to
clean, brightly lit and easily
accessible.
•
Insert the mains plug into a
socket with earthing contacts.
Page | 22

11.1 Starting the egg boiler

1. Place the appliance on a
flat, level and dry surface.
2. The surface should be non-
slip and heat resistant.
3. Fill the supplied measuring
cup fully with cold water
and pour it into the egg
boiler.
4. Insert the egg holder.
5. Pierce each egg at the
bottom with the egg piercer
at the bottom of the
measuring cup to avoid
cracking. Carefully press
the egg on the piercer.
6. Place the eggs with the
pierced side up evenly
spaced in the egg holder.
7. Close the hood.
8. Connect the power plug to
a properly installed wall
outlet.
9. Set the hardness control to
the desired position as
described under "Hardness
Setting".
10. Turn the appliance on. The
status indicator lights up.
11. The acoustic signal sounds
as soon as the eggs reach
the desired hardness. Turn
the appliance off and
disconnect from mains
power supply.
12. Remove the hood only by
taking hold of the handle.