Qlima FSM 40 TOUCH Manuel D'utilisation page 47

ASSEMBLING THE MIST FAN
The manufacturer is not responsible for any harm or damage if attention is
not paid to the points described above.
The use of this product and the elements required for that purpose is entirely
at the end user's own risk.
To assemble the safety grille and blade assembly, remove the spinner (by
turning it clockwise), then the locking nut (by turning it anticlockwise) from
the motor spindle. Place the back safety grille into position. Ensure the safety
grille fits onto the locating lugs. If this is done correctly, the safety grille's
carry handle will be at the top. To assemble the safety grille and blade
assembly, remove the spinner (by turning it clockwise), then the locking nut
(by turning it anticlockwise) from the motor spindle. Fix the safety grille into
position by replacing the locking nut tightly by hand.
Do not force the locking nut.
The groove in the centre of the fan blade aligns with a T-bar on the motor
spindle to ensure correct positioning.
Fix the blade into place by gently hand tightening the spinner (Fig.2)
anticlockwise onto the end of the motor spindle. The spinner is self-
tightening; do not force it.
Water tank Assembly
Take out water tank first, and then take out valve body cover from water tank,
and then put the water in the tank and tighten the valve body cover. Put the
tank on atomizer Main Body,the temperature of water should not above 40
Main body
cover
(Fig.4)
Locking nut
(Fig.1)
Spinner tightens
anticlockwise
(Fig.2)
Valve body
Water tank
cover
O
C.
Loosen
Tighten
4
47