Moving The Unit; Warning Signs; Power Handling - Vision SP-5000 Guide De L'utilisateur

USE ONLY DOMESTIC AC OUTLETS
Connecting the unit to an outlet supplying a higher voltage may create a fire hazard.
HANDLE THE POWER CORD WITH CARE
Do not disconnect the plug from the AC outlet by pulling the cord; always pull the plug itself.
Pulling the cord may damage it. If you do not intend to use your unit for any considerable length
of time, unplug the unit. Do not place furniture or other heavy objects on the cord, and try to
avoid dropping heavy objects on it. Do not tie a knot in the power cord. Not only could the cord
be damaged, but a short circuit could also be caused with a consequent fire hazard.
PLACE OF INSTALLATION
Avoid installing this product under the following conditions:
• Moist or humid places
• Places exposed to direct sunlight or close to heating equipment
• Extremely cold locations
• Places subject to excessive vibration or dust
• Poorly ventilated places
Do not expose this product to dripping or splashing. DO NOT PLACE OBJECTS FILLED WITH
LIQUIDS ON OR NEAR THIS PRODUCT!

MOVING THE UNIT

Before moving the unit, be sure to pull out the power cord from the AC outlet and disconnect
the interconnection cords with other units.

WARNING SIGNS

If you detect an abnormal smell or smoke, turn this product off immediately and unplug the
power cord. Contact your reseller or Vision.
PACkAGING
Save all packing material. It is essential for shipping in the event the unit ever needs repair.
IF ORIGINAL PACkAGING IS NOT USED TO RETURN THE UNIT TO THE SERVICE CENTRE, DAMAGE
IN TRANSIT WILL NOT BE COVERED BY WARRANTY.

POWER HANDLING

The power rating given denotes the "power handling" of the speaker (not power output). These
speakers are rated to accept up to 20 watts RMS each.
Care should be taken to use an amplifier which has a power output of 10-100w RMS. An
amplifier which is too small may send loudspeakers a distorted signal which is causes damage
very quickly and WITHOUT any obvious signs such as audible distortion, whereas an amplifier
which is too large may send a signal which is too powerful and will cause damage if sustained
over a period of time.
2