Troubleshooting Guide - Ergo tools Pattfield PE-EBH 7530 Mode D'emploi D'origine

11. Troubleshooting guide

Fault
Motor does not start
Motor performance
drops
Notice! For protection, the motor is equipped with a thermal switch which cuts out when the
motor is overloaded and switches on again automatically after a short cooling period.
Anl_PE_EBH_7530_SPK7.indb 91 Anl_PE_EBH_7530_SPK7.indb 91
GB
Possible causes
- No power at the plug
- Cable defective
- Switch/plug block defective
- Motor terminals or capacitor
disconnected
- excessive working depth
- Soil too hard
- Blades badly worn
- 91 -
Remedy
- Check the power cable and fuse
- Check
- By customer service workshop
- By customer service workshop
- Reduce working depth
- Correct working depth
- Replace hoe blades
09.10.14 08:23 09.10.14 08:23