Atag VD1674M Mode D'emploi page 21

DESCRIPTION AND USE
Starting Dry Run Function
After using the vacuum drawer for a period of time, there will be
moisture in the oil of the vacuum pump. Because of this, the device
may vacuum insufficiently. It is then advised to perform the Dry Run
Function. If vacuuming does not work, then the Vacuuming Failure
indicator and the Dry Run Function indicator light up. After a number of
warnings (Vacuuming Failure indicator and Dry Run Function indicator
lighting up), it is advised to perform the Dry Run Function.
1. Press the Dry Run Function touch key to start the Dry Run Function.
2. Immediately afterwards, shortly press on the front of the lid so that
the vacuum chamber can vacuum.
The Dry Run Function symbol flashes during drying.
Note! If the Dry Run Function does not completely remove the
moisture from the oil after a maximum of 20 minutes, then the drawer
switches to a 'cool off' setting. The vacuum drawer can then not be
used for a period of one hour. The Dry Run Function indicator is visible
in the display. After that, start the Dry Run Function again!
Regular use of the Dry Run Function is part of the normal operation
of the vacuum drawer.
EN 9