English; Important - Philips Performer FC9153/11 Mode D'emploi

ENGLISH

6

Important

Read these instructions for use carefully before using the appliance and save them for future
reference.
Check if the voltage indicated on the appliance corresponds to the local mains voltage before
you connect the appliance.
Do not use the appliance if the plug, the cord or the appliance itself is damaged.
If the mains cord of this appliance is damaged, it must be replaced by Philips, a service centre
authorised by Philips or similarly qualified persons in order to avoid a hazard.
Keep the appliance out of the reach of children.
Never suck up water or any other liquid. Never suck up flammable substances and do not
suck up ashes until they are cold.
Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum
cleaner is switched on and the hose is connected to the vacuum cleaner.
When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become
clogged, causing the passage of air through the dustbag to become obstructed.As a result, the
dustbag-full indicator will indicate that the dustbag needs to be replaced, even though the
dustbag is not full at all (see chapter 'Replacing the dustbag').
Never use the appliance without the Motor Protection Filter.This could damage the motor
and shorten the life of the appliance.
Only use Philips s-bag` double-layer paper dustbags.
The translucent display panel is made of recyclable polycarbonate (>PC/ABS<).
Preparing for use
Connecting accessories
Hose
1 To connect the hose, push it firmly into the appliance ('click') (fig. 1).
2 To disconnect the hose, push the buttons and pull the hose out of the appliance (fig. 2).
Telescopic tube
1 Connect the tube to the handgrip by pressing the spring-loaded lock button on the handgrip
and inserting the handgrip into the tube. Fit the spring-loaded lock button into the opening in
the tube ('click') (fig. 3).
2 To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the
handgrip out of the tube.
Use the same method to connect and disconnect the nozzles.
3 Adjust the tube to the length you find most comfortable during vacuum cleaning (fig. 4).
Tri-Active nozzle
The Tri-Active nozzle is a multi-purpose nozzle for carpets and hard floors (fig. 5).
The side brushes catch more dust and dirt at the sides of the nozzle and allow you to clean better
along furniture and other obstacles.
The opening at the front of the nozzle allows you to suck up larger particles (fig. 6).
Hard floor setting:
1 Push the rocker switch on top of the nozzle with your foot to make the brush strip come
out of the housing.At the same time the wheel will be lifted to prevent scratching and to
increase manoeuvrability (fig. 7).