Instructions For Sloping Roof Installation - Ferroli VF Instructions De Montage

INSTRUCTIONS FOR SLOPING ROOF INSTALLATION

TIVG
box kit
x 4
x 2
x 2
x 6
(TCEI M8x75)
x 2
(55x20x347)
The TIV kit is used for only one collector.
A
10 N/m
B
10 N/m
2 - Fit the brackets and fix them with the M8X75 hex. socket screws.
10 N/m
3 - Fix the supporting structures on the fastenings previously prepared on the roof depending on the type of covering.
Notes:
When high stresses on the structure are foreseen (e.g. heavy snowfall, wind gusts, etc.) it is advisable to increase the fixing points as given in
the diagram on page 5
Important:
The weights of the collector and any additional weights will be supported by the brackets which in turn will rest on the roofing tiles.
Therefore correctly check their load bearing capacity before carrying out installation
26
EN
(60x25x1195)
1 - Assemble the supporting structures according to the number of collectors to be installed,
fitting the profiles together.
TIV
= 110
3
Min
65mm
Cod. 3540S892 - 01/2010 (Rev. 00)
L
8xTIV L= 9567
2
= 110
10 N/m
2TIV
= 110
3
20 N/m
VF
2
= 225
3