Table des Matières
Publicité
3.
Install the Console Table Legs
Legs/Pieds/Patas
Rack
Rail
Rejilla
Using the diagram above, mark the positions of the legs on the finished floor.
Using a 1/4" drill bit, drill a minimum of 1/2" (1.3 cm) into the finished floor at
the marked positions.
Insert bushings into the top corners of the console table legs.
Ensure the adjustable feet are fully retracted.
With assistance, slightly lift the lavatory while sliding the console table legs into
position. Position the console table legs so the bushings are inserted into the 1/4"
(6 mm) holes on the underside of the lavatory.
Turn the adjustable feet counterclockwise until each foot is fully engaged into the
drilled holes in the finished floor. The adjustable feet should fit snug into the
finished floor, not forced.
Verify the lavatory and the console table legs are level. Adjust as needed by
turning the adjustable feet or tightening and retightening the bolts on the
underside of the lavatory.
Rest the rack on the bottom leg assembly, as shown.
Installer les pieds de la table de console
Utiliser le diagramme ci-dessus pour marquer les emplacements des pieds sur le
plancher fini.
Avec une mèche de 1/4", percer un minimum de 1/2" (1,3 cm) dans le sol fini,
aux emplacements indiqués.
Insérer les coussinets dans les coins supérieurs des pieds de la table de console.
Kohler Co.
Finished Wall
Mur fini
Pared acabada
23" (58.4 cm)
Bushing
Bague
Buje
Leg Assembly
Ensemble de pied
Montaje de patas
Adjustable Feet
Pied réglable
Pie ajustable
Lado inferior del lavabo
9
2" (5.1 cm)
15-1/2"
(39.4 cm)
Insert/Insertion/Inserto
Underside of lavatory
Dessous du lavabo
1007272-2-C
Publicité
Table des Matières
